Taillamp/rear fog lamp bulb, removing and installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
- Unclip plug - 1 - from luggage compartment trim - arrow - using a small screwdriver.
- Remove nut - 1 - and detach retainer bracket.
- Remove bulb holder - 2 - from housing (press apart retaining tabs - arrows - ).
- Screw bulb out of bulb holder.
Installing
Install in reverse order of removal, noting the following:
- Insert new bulb in bulb holder.
Tightening torque
| Component - fastener | Nm |
| Retainer bracket to housing - nut | 3.5 |