Rear light/bulb carrier in rear fender - Sedan, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Turn light switch to position "0".

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Fig 1: Identifying Pre-punched Area Of Luggage Compartment Lining, Fastener, And Rear Light

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Fold pre-punched area - 2 - of luggage compartment lining forwards.
Remove fastener - 1 - (17 mm hex socket ).
Swivel rear light outwards - arrow - , and at the same time disengage retaining pins from body.
Disconnect electrical connection at bulb carrier.

Fig 2: Pressing Together Retaining Tabs And Removing Bulb Carrier From Rear Light

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Press together retaining tabs - arrows - and remove bulb carrier - 1 - from rear light.
Turn bulbs to remove them from their holders.

Installing

Install in reverse order of removal, noting the following:

NOTE:

Ensure seal between body and rear light housing seals completely.
Fit rear light in position on body and press retaining pins into holes.

Tightening torque

Component - fastener	Nm
Rear light to body - screw	3.5