Rear parking aid sensors, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Parking Aid Sensors In Rear Bumper Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Location: In rear bumper cover - arrows -.

Removing

Remove rear bumper cover → 63 BUMPER

Fig 2: Identifying Electrical Connection, Catches, And Sensor

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect applicable electrical connection - 1 - from sensor.
Press both catches - arrows - to side and press sensor - 2 - inward from outside.

Installing

Install in reverse order of removal, noting the following:

Install rear bumper cover → 63 BUMPER .