Turn signal/parking lamp bulb, replacing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- HIGH VOLTAGE!
- Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE" warning symbols.
Removing
- Remove headlamp → Headlamps, removing and installing .
- Turn bulb holder - arrow - counter-clockwise and pull it from housing.
- Pull bulb out of bulb holder.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing bulb holder, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in housing.
- Install headlamp Installing .