High Beam Headlamp bulb M30 / M32, replacing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

HIGH VOLTAGE!
Always disconnect negative ( - ) battery terminal prior to working on parts of HID headlamp components marked with yellow "HIGH VOLTAGE" warning symbols.

Removing

Remove headlamp → Headlamps, removing and installing .

Fig 1: Removing Screws And Retaining Clip

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - 1 - and - 2 -.
Release retaining clip - 3 - in direction of - arrow - and detach housing cover from headlamp housing.

Fig 2: Turning Bulb Clockwise And Removing From Housing/Disconnecting Electrical Connection

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Turn bulb - 1 - clockwise - arrow - and remove from housing.
Disconnect electrical connection - 2 -.

Installing

Install in reverse order of removal, noting the following:

CAUTION:

Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.

Fit new bulb in housing.
Secure bulb by turning in counter-clockwise direction.
Secure housing cover with screws and retaining clip.
Install headlamp Installing .

Reconnect battery. Required steps Reconnecting .