Headlamps, removing and installing: Installing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal, noting the following:
- Check adjusting nut - 1 - of adjuster for freedom of movement - arrows -.
- Screw adjusting nut as far as it will go, but do not tighten.
- Insert headlamp and screw in screws - 1... 3 - two complete turns.
- Install front bumper cover → 63 BUMPER .
- Align headlamp with body contours and front bumper cover (note gap widths).
- Tighten screws in sequence - 2 - , - 1 - and - 3 -.
NOTE:
- When the screws are tightened the adjusting nut of the adjuster element automatically rotates against the mounting point of the headlamp housing and fixes it in place.
- Check gaps; if necessary, repeat procedure for installing headlamp.
- Reconnect battery. Required steps Audi A4 S4 Reconnecting . Required steps Audi RS4 Connecting
- Following installation, check and adjust headlamps if necessary → 00 - TECHNICAL DATA .
Tightening torque
| Component - fastener | Nm |
| Headlamp to lock carrier - screw | 4.5 |