Daytime Running Lamp (DRL) bulb, replacing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Right headlamp
- Remove screws - arrows -.
- Remove air ducts - 1 - and - 2 -.
Both sides, continued:
- Release retaining tab - arrow - and detach housing cover for side lights from headlamp housing.
- Turn bulb holder - 1 - counter-clockwise - arrow - and remove from headlamp housing.
- Screw bulb out of bulb holder.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in housing.
- Secure bulb holder by turning clockwise.
- Close housing cover.