High Beam Headlamp M30 / M32 - bulb, replacing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Turn light switch to position "0".

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Left headlamp

Fig 1: Removing Cover In Engine Compartment (Left Side)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove left engine cover - 1 -.

Fig 2: Disconnecting Electrical Connections From Retainer And Removing Retainer

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connectors - 1 - and - 2 - from retainer.
Unclip retainer for connectors and pull off upwards - arrow -.

Additional preparation:

Right headlamp - vehicles with 1.8L 4-cylinder Turbo engine:

Remove air cleaner housing.

Right headlamp - vehicles with 3.0L 6-cylinder engine:

Remove air cleaner housing.

Right headlamp - vehicles with 4.2L 8-cylinder petrol engine:

Remove air cleaner housing.

Fig 3: Releasing Retaining Clip And Detaching Housing Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Both sides, continued:

Release retaining clip - arrow - and detach housing cover for high beam from headlamp housing.

Fig 4: Identifying Electrical Connection, Retaining Clip, And Bulb

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connection - 3 - at high beam headlamp bulb.
Release retaining clip - 2 - and remove bulb - 1 - from housing.

Installing

Install in reverse order of removal, noting the following:

CAUTION:

Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
When installing housing cover, ensure proper seating. Water intrusion will damage headlamp.

Fit new bulb in housing.
Secure bulb with retaining clip.
Secure housing cover with retaining clip.