Headlamps, removing and installing: Removing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect battery → Battery in engine compartment, disconnecting and reconnecting .
Left headlamp
- Remove left engine cover - 1 -.
Right headlamp
- Remove right engine cover - 1 -.
- Remove screws - arrows -.
- Remove Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 N80 - 1 - at air duct.
- Remove air duct - 2 -.
Both sides, continued:
- Use adhesive tape to mask area beneath headlamp to prevent damage to paintwork.
- Remove screws - 1 - and - 5 -.
- Loosen screws - 2 - and - 4 - a few turns but do NOT remove completely.
- Where applicable, cut through cable tie.
- Disconnect electrical connection - 3 -.
- Remove headlamp from body towards front.