Front Turn Signal Lamp M5 / M7 - bulb, replacing
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
Left headlamp
- Remove washer fluid reservoir → Washer fluid reservoir - Audi A4 S4, removing and installing .
Right headlamp
- Lift vehicle.
- Remove right front wheel.
- Remove screws - arrows -.
- Remove forward portion of wheel housing liner.
Continuation for all:
- Turn bulb holder - 3 - counter-clockwise - arrow - and pull out from housing.
- Screw bulb out of holder.
Installing
Install in reverse order of removal, noting the following:
CAUTION:
- Do not touch glass portion of bulb with bare hands. Even the smallest amount of moisture and/or contaminants from fingers that evaporates on the bulb during operation can cause the glass to cloud over.
- When installing bulb holder, ensure proper seating. Water intrusion will damage headlamp.
- Fit new bulb in bulb holder.
- Markings - 1 - and - 2 - must be opposite each other when inserting bulb holder into housing.
Left headlamp
- Install washer fluid reservoir → Washer fluid reservoir - Audi A4 S4, removing and installing .
Right headlamp
- Install wheel housing liner → 66 EXTERIOR EQUIPMENT .