Fog lamp housing, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Turn light switch to position "0".

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Audi A4:

Fig 1: Releasing Catches Using Screwdriver And Removing Air Intake Grille On Left/Right On Bottom Part Of Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release retaining hooks - 1... 4 - using a screwdriver - arrow - and pull off air intake grille in bottom section of bumper.

Audi S4:

Fig 2: Identifying Screw, Air Intake Grille, And Retaining Clip

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Turn screw - 1 - 90 ° (1/4 turn).
Remove air intake grille from fog lamp housing in direction of - arrow A -.
Then push air intake grille in direction of - arrow B - and simultaneously disengage retaining clip - 2 -.
Remove air intake grille.

All models:

Fig 3: Identifying Screws For Fog Lamp Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows -.
Disengage fog lamp housing and remove.
Disconnect electrical connection.

Installing

Install in reverse order of removal, noting the following:

Engage fog lamp housing.
Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .

Tightening torque

Component - fastener	Nm
Fog lamp housing to bumper - screw	5