Fog lamp housing - Audi A4, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Turn light switch to position "0".

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Vehicles without charge air cooler:

Fig 1: Identifying Quick-Release Fasteners And Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Release fasteners - 1 - and - 2 - and remove front noise insulation.

Vehicles with charge air cooler:

Remove front bumper cover → 63 BUMPER .

All models:

Fig 2: Identifying Screws, Electrical Connection, And Fog Lamp Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows -.
Disconnect electrical connection - 2 -.
Remove fog lamp housing - 1 -.

Installing

Install in reverse order of removal, noting the following:

Vehicles with charge air cooler:

Install front bumper cover → 63 BUMPER .

All models:

Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .

Tightening torque

Component - fastener	Nm
Fog lamp housing to bumper cover - screw	6