Fog lamp housing - Audi A4 with "S-line" equipment Audi S4, removing and installing

WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Turn light switch to position "0".

CAUTION:

Switch off all electrical consumers.
Switch ignition off and remove ignition key.

Fig 1: Removing Air Intake Grille From Fog Lamp Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove air intake grille from fog lamp housing in direction of - arrows -.

Fig 2: Locating Screws For Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove screws - arrows -.
Disconnect electrical connection.
Remove housing from opening.

Installing

Install in reverse order of removal, noting the following:

Check and adjust fog lamps if necessary → 00 - TECHNICAL DATA .

Tightening torques

Component - fastener	Nm
Fog lamp housing to bumper cover - screw	6