Dual-mass flywheel or flywheel for automatic transmission 01J: Installing

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, noting the following:

NOTE: Needle bearing is located in the flywheel and must be driven in when flywheel is replaced. Refer to Dual-mass flywheel pilot needle bearing, removing and installing

Replace bolts and tighten.
Install clutch pressure plate.

Refer to

30 CLUTCH for 5 SPD. MANUAL TRANSMISSION 012/01W FRONT WHEEL DRIVE
30 CLUTCH for 5 SPD. MANUAL TRANSMISSION 01A ALL WHEEL DRIVE
30 CLUTCH for 6 SPD. MANUAL TRANSMISSION 01E ALL WHEEL DRIVE
30 CLUTCH for 6-SPEED MANUAL TRANSMISSION 01X, FRONT-WHEEL DRIVE
30 CLUTCH for 6-SPEED MANUAL TRANSMISSION 02X, FOUR-WHEEL DRIVE
30 CLUTCH for 6-SPEED MANUAL TRANSMISSION 0A3, ALL WHEEL DRIVE

Install damper unit: Refer to Installing .
Remove T10026 alignment bolt and thread sealing plug of TDC marking with new O-ring into cylinder block.