Tightening torques
WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Tightening torques are valid only for nuts and bolts that are lightly greased, oiled, covered with a thin coat of phosphate or blackened.
- Other lubricants are permitted, e.g. engine oil or transmission fluid, however they may not contain graphite.
- Do not use any degreased parts.
- Tightening torque tolerance ± 15%.
Securing engine/transmission for manual transmission
| Item no. | Bolt | Nm |
| 1, 9, 10, 11 | M10 x 60 | 45 |
| 2 | M10 x 150 | 45 |
| 3 | M12 x 130 | 65 |
| 4 | M12 x 80 | 65 |
| 5, 6, 8 | M12 x 90 | 65 |
| 7 | M10 x 100 | 45 |
A: Alignment bushing
Securing engine/transmission with automatic transmission 01J
| Item no. | Bolt | Nm |
| 1, 10, 11 | M10 x 60 | 45 |
| 2 | M12 x 90 | 65 |
| 3 | M12 x 110 | 65 |
| 4 | M12 x 80 | 65 |
| 5, 6 | M12 x 90 | 65 |
| 7 | M10 x 100 | 45 |
| 8 | M12 x 75 | 65 |
| 9 | M10 x 70 | 45 |
A: Alignment bushing
Securing engine/transmission with automatic transmission 01V
| Item no. | Bolt | Nm |
| 1, 9, 10, 11 | M10 x 60 | 45 |
| 2 | M10 x 90 | 45 |
| 3 | M12 x 110 | 65 |
| 4 | M12 x 80 | 65 |
| 5, 6, 8 | M12 x 90 | 65 |
| 7 | M10 x 100 | 45 |
A: Alignment bushing
| Component | Nm | ||
| Nuts/Bolts | M6 | 10 | |
| M8 | 20 | ||
| M10 | 45 | ||
| M12 | 65 |
| Component | Nm | ||
| Except for the following: | |||
| Drive plate to torque converter | M10 x1 | 85 | |
| Torque support to oil pan (upper part) | 40 | ||
| Engine mount to | Engine support | 23 | |
| Carrier | 23 | ||
| Heat shield for driveshaft to transmission | 23 | ||
| Oil cooler to oil pan (upper part) | 30 | ||
| Power steering pressure line to | |||
| Pressure hose | 40 | ||
| Coolant pipe | 20 | ||
| Air guide to intake manifold | 10 | ||
| Fuel supply line to fuel rail | 22 | ||
| Wiper arm to wiper axle | 21 | ||
| ATF hose to ATF tube | 29 | ||