Cover and padding for head restraint with slide-in locking mechanism, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cover And Upholstery For Headrests With Slide In Locking Mechanism Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove head restraint with slide-in locking mechanism → Head restraint, removing and installing .
Using a screwdriver, pry out securing strips - 3 - (4x).
Detach knob - 2 -.
Detach cover and padding - 1 -.

Fig 2: Identifying Padding, Cover & Head Restraint Mount

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove padding - 2 - from cover - 3 -.

Installing:

Insert padding - 2 - correctly into cover - 3 -.
Insert head restraint mount - 1 - into padding with cover.
Press fastening strips firmly into guide channel (pull to check).