Lumbar support adjustment motors, assembly overview
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- On the drivers seat in the illustration, the lumbar support height adjustment motor is on the left and the lumbar support adjustment motor is on the right.
1 - Lumbar support adjustment motors (2x)
- Remove seat → Seat, assembly overview .
- Attach fixture for seat repair VAS 6136 to engine and transmission holder VAS 6095.
- Attach front seat to fixture for seat repair VAS 6136.
- Remove backrest cover panel → Backrest cover panel, removing and installing .
- Disconnect connector.
- Remove bolts.
- Disengage Bowden cable at 4-way lumbar support.
- Replace motor.
2 - Seat height adjustment motor
3 - Seat inclination adjustment motor
4 - Forward and backward seat adjustment motor
5 - Backrest adjustment motor