Front anchorage point for outer floor panel
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- Removing
- Detach trim cap - 3 -.
- Remove bolt - 2 -.
- Tightening torque 55 Nm
- Remove washer - 4 -.
- Swing clip - 5 - upward.
- Remove belt - 1 - from clip - 5 -.
- Installing
- Install washer - 6 - under clip - 5 -.
- Continue installing anchorage point for outer floor panel in reverse order of removal.