Child-seat restraint function for additional child seats (not for drivers seat belt), checking
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
- The complete belt assembly (including side panel trim) must be installed when checking this function.
- Activation of restraint function:
- Pull out webbing as far as possible.
- Correct function:
- The belt should retract with an audible noise.
- If the belt retraction is stopped, it should not be possible to pull the belt out again until the function is deactivated.
- Deactivation:
- Allow the belt to retract as far as the last 100 mm (approx.).
- Restraint function must be deactivated at the latest when the last 100 mm are reached. The belt then re-assumes its normal function.