Steering wheel (multi-function steering wheel), assembly overview
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Torx bolts T30 (2x)
- Tightening torque 7 Nm
2 - Steering wheel
- Removing
- Remove airbag unit (multi-function steering wheel) → Refer to → Airbag unit (multi-function steering wheel), assembly overview .
- Center steering wheel (wheels in straight-ahead position).
- Remove bolt - 6 -.
- Disconnect connector for coil - 3 -.
- Disconnect multi-function cable connector - 9 -.
- Heated steering wheel: Unplug connector for heated steering wheel - 10 -.
- Remove steering wheel - 2 -.
- Installing
- Installation is in reverse order of removal.
- Ensure that connector and catch engage fully (i.e. audibly).
- Insert supply cable - 7 - in clip - 8 -.
- Attach steering wheel in center position (wheels in straight-ahead position).
- Replace bolt - 4 - and tighten to 50 Nm.
3 - Connector for coil
4 - Connector for airbag unit
5 - Airbag unit
6 - Multi-point socket head bolt
- Tightening torque 50 Nm
7 - Supply cable
8 - Clip
9 - Connector for multi-function steering wheel
10 - Connector for heated steering wheel
11 - Self-cancelling ring with slip ring