Mounting holes for telephone handset bracket in center console, fabricating
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
When supplied as a spare part, center console has no mounting holes for telephone handset bracket. Mounting holes must be created.
- Remove center console → Center console, assembly overview .
- Fabricate mounting holes of the following dimensions:
a - 10 mm
b - 6 mm
c - 22 mm
d - 101 mm
e - 25 mm
f - 16 mm
g - 5 mm
h - 8 mm
- Engage threaded molding in center console from rear and fasten bracket with a torque of 1.5 Nm.
NOTE:
- After installation check that glove compartment lid will open.