Left instrument panel trim, removing and installing
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Special hook 3370
- Torque wrench V.A.G 1783
Removing
- Remove storage compartment on drivers side → Drivers side storage compartment (with and without knee bolster), removing and installing .
- Pull off left instrument panel cover - arrow - using special hook 3370.
- Press light switch - arrow 1 - and turn toward right simultaneously - arrow 2 -.
- Hold switch in this position and remove light switch from switch housing - 3 -.
- Disconnect electrical connector.
- Press headlamp range control adjuster out of switch housing.
- Disconnect electrical connector.
- Remove bolts - 1 - (3x).
Tightening torque: 3 Nm.
- Remove the trim.
Installing
Installation is reverse of removal.