Steering wheel, removing and installing (standard steering wheel)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Torque Wrench V.A.G. 1331

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1331

Fig 2: Identifying Vehicle Diagnosis, Testing And Information System VAS 5051

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Vehicle Diagnosis, Testing and Information System VAS 5051 A

Fig 3: Steering Wheel (Standard Steering Wheel) Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - bolts T30 (Qty. 2)

Tightening torque 7 Nm

2 - Steering wheel

Removal:

Remove airbag unit (standard steering wheel) → Airbag unit, removing and installing (standard steering wheel) .
Bring steering wheel to center position (wheels straight).
Remove screw - 7 -.
Remove spiral spring connector - 3 -.

With steering wheel heating: Remove steering wheel heating connector - 8 -.
Remove steering wheel - 2 -.

Installing:

Installation is reverse of removal. Observe the following when doing so:

Ensure connector and securing clip engage completely (audibly).
Attach steering wheel in center position (wheels straight).
Replace bolt - 7 - and tighten it to 50 Nm.

3 - Spiral spring connector

4 - Airbag unit connector

5 - Airbag unit

6 - Horn connector

7 - Socket head bolt

Tightening torque 50 Nm

8 - Steering wheel heating connector

9 - Coil connector with slip ring