License plate securing holes, creating
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Four punch marks are present in the bumper cover license plate field. They must be drilled out to secure a license plate (measurements 115 x 520 mm).
If centering punch marks are not visible, proceed as follows:
- Determine vertical bisecting line from Audi emblem to center of grill on bumper.
- Determine horizontal bisecting line:
- Dimension - a - = Dimension - a -.
- Determine mounting points for license plate symmetrically as follows:
- Dimension - x - = 139 mm
- Dimension - y - = 62 mm