Adjusting support piece
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- When turning adjustment screw - 3 - , make sure mounting bracket - 4 - raises.
- If mounting bracket does not raise, place a small drop (very small!) of locking compound D 000 600 A2 on the adjustment screw threads - 3 - and allow locking compound to dry.
- Turn adjustment screw up to dimension - a -.
- The mounting bracket raises when adjustment screw is turned due to the increased friction.
- Before installing bumper cover - 1 - , adjust adjusting screw - 3 - on support piece - 5 - to dimension - a - = 21 mm +1 mm.
- Mounting bracket - 4 - must be screwed on completely (left-hand thread) for this.
- Adjustment screw - 3 - and mounting bracket - 4 - belong to delivery casing for support piece and are not replacement parts.
- When installing bolt - 3 - , mounting bracket - 4 - unscrews and holds the carrier piece - 2 - of bumper cover - 1 - in the designated position.
- The support piece - 5 - is secured to bumper cover - 6 - with pop rivets.