Rear lid lock and handle mechanism, removing and installing

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Lid Lock And Handle Mechanism Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

1 - Rear lid lock

To remove, unclip operating rod from swiveling bush and disengage.

2 - Swiveling bush

After installing rear lid lock, engage operating rod and secure.

3 - Nut

8 Nm

4 - Operating rod

5 - Release

6 - Lock cylinder

Removing:

Disconnect electrical connectors.
Disengage release from lock cylinder.
Remove bolt.
Twist lock cylinder 90°.

Remove lock cylinder from handle mechanism.

7 - Screw

8 Nm

8 - Motor

Country versions

9 - Handle

Removing:

Remove rear lid trim.
Remove lock cylinder.
Remove bolts.
Press in catches - arrows -.

Remove grip piece.

10 - Nut

8 Nm