Hood, removing, installing and adjusting (from model year 2006): Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2009 Audi S4, 2009 Audi A4, 2008 Audi S4, 2008 Audi RS 4, and 2008 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
From model year 2006
1 - Hood
- Removing:
- Disconnect line to windshield washer system and unclip line.
- Second person is required to support and lift hood.
- Remove gas-filled strut - 5 - from hood - 1 - Gas-filled strut, removing and installing .
- Remove nuts - 4 -.
- Remove hood.
- Installing:
- Install in reverse order of removal.
- Adjusting:
- Align hood - 1 - between fenders.
- Adjust height of hood at hood lock Removing and installing lower part of hood lock .
2 - Hood hinge
- Hood - 1 - must be removed or propped up securely.
- To remove, remove bolts - 3 - and nuts - 4 -.
3 - Screw
- 21 Nm
4 - Nut
- 21 Nm
5 - Gas strut
- Tube of gas-filled strut must be installed on body side