Adhering centering pins on side impact molding
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Adhesive - 3 - and centering pin - 4 - (3x each) are in delivery casing of side impact molding - 1 -.
- Remove protective foil from the double-sided adhesive - 3 - and adhere it onto centering pin - 4 -.
- Remove second protective foil and position centering pin onto marking - arrow - on side impact molding.
- Remove protective foils from double-sided adhesive strips - 2 - and press side impact molding - 1 - onto bumper.