Disengaging support piece
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Never disengage support piece in the removed condition - danger of injury.
When re-installing the old bumper cover, the old support piece remains installed.
- When replacing the bumper cover, a new support piece must be clipped into the bumper cover from below.
- After completely installing bumper cover, disengage support piece by pulling on disengaging cord - arrow -.
NOTE:
- By pulling disengaging cord, tension is released from support piece and reinforces the bumper cover against the crossmember.