Positioning license plate mounting holes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
There are four centering punch marks on license plate area of bumper cover which must be drilled through for securing a license plate (dimensions 115 x 520 mm).
If centering punch marks are not visible, proceed as follows:
- Determine vertical bisecting line from Audi emblem to center of grill on bumper.
- Determine horizontal bisecting line:
- Dimension - a - = dimension - a -
- Determine mounting points for license plate symmetrically as follows:
- Dimension - x - = 139 mm
- Dimension - y - = 62 mm