Positioning centering holes
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.
- Position of long holes is indicated by markings on bumper.
- Long hole must be aligned to dimensions - a - = 8.5 mm and b = 15.5 mm as shown
- If there is no marking in this area, the long hole must be aligned according to the indicated lines on bumper as shown, with upper edge to horizontal line and with outer edge to vertical line.
- Dimension - a - = 8.5 mm.
- Dimension - b - = 15.5 mm.