Gas-filled strut for rear lid, removing and installing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Prop up and secure rear lid in open position.

Fig 1: Using Screwdriver To Lift Retaining Spring And Remove Gas-Filled Strut From Upper Ball Stud

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Using screwdriver, lift retaining spring - 3 - as shown and remove gas-filled strut - 1 - from upper ball stud - 2 -.

NOTE:

Following complete removal of the gas-filled strut, check for correct positioning during installation.
Sound insulation component must be installed on the body side.

NOTE:

Installing

Installation is the reverse of removal, noting the following:

To install, press gas-filled strut onto ball studs so that it engages in position.
Ball stud tightening torque: 15 Nm^{-1 Nm}