Releasing gas from gas-filled strut

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Gas-filled Strut Area To be Clamped in Vice

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Clamp gas-filled strut in vice area x. Dimension of - x - = 50 mm (2 in.).

CAUTION: Clamping must only be done in this area, otherwise there is a risk of an accident.

Always wear eye protection when performing this procedure.

Cover area of sawn portion with a rag to absorb oil spraying out.

Using saw, cut into cylindrical part of strut at point within first third of cylinders length (measured from cover edge at piston rod end of cylinder).