Selector lever handle (from VIN 8E_6A156500), removing and installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2009 Audi A4, 2008 Audi A4, 2007 Audi A4, 2006 Audi A4, and 2005 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Removing
- Place selector lever in position "D".
- Rotate sleeve - 1 - to left and push downward as far as stop.
- Carefully pull switch - 2 - just enough out of selector lever handle - 3 - until a cable tie can be inserted between button and selector lever handle.
NOTE:
- Do not pull out the button any further, otherwise the selector lever handle will be damaged.
- Secure button in pulled-out position using cable tie - arrow - as shown in illustration.
- Pull selector lever handle upward and off.
Installing
Installation is in reverse order of removal, note the following:
- Place selector lever in position "D".
NOTE:
- To install new selector lever handle - 3 - , button - 2 - must be pulled out as far as stop and secured with a cable tie - arrow - or using assembly aid included with new handle.
- If the button was not secured, it must not be pulled out from the handle using mechanical aids. Apply compressed air gun to bottom of handle and press button out with compressed air.
- Place selector lever handle - 3 - completely onto selector lever - button - 2 - faces toward driver. When doing this, handle must engage into ring groove of selector lever.
- Remove cable tie - arrow - or assembly aid, thereby the button mechanism engages in the vertical groove of the selector lever. If necessary press button into selector lever handle.
- Pull sleeve - 1 - upward and engage by rotating clockwise.