Transfer gear oil level, checking
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2009 Audi A4, 2008 Audi S4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools, testers and auxiliary items required
- Drip tray V.A.G 1306
- Safety goggles
Condition
- Gear oil about 20° C (room temperature)
Work sequence
- Drive vehicle onto a four-column hoist or over an inspection pit so that it is absolutely horizontal.
- Place drip tray V.A.G 1306 under transmission.
CAUTION:
Wear safety goggles.
- Remove plug - arrow -.
- The oil level must be up to lower edge of filler hole.
- Top off with gear oil if necessary; specification → Transfer gear .
NOTE:
- The plug with seal must be replaced.
- Tighten new plug to 35 Nm.