Transmission Input Speed (RPM) Sensor G182 (transmission with hydraulic control "E18/2"), removing and installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

On a transmission with hydraulic control "E18/2" , Transmission Input Speed (RPM) Sensor G182 is a Hall sensor (secured behind valve body on transmission housing).
The allocation of the hydraulic control can be found in Technical Data → 00 - GENERAL, TECHNICAL DATA .

Removing

Remove valve body → Valve body, removing and installing .

Fig 1: Sensor For Transmission RPM (Transmissions With Hydraulic Regulation -E18/2-)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove bolt - B -.
Remove Transmission Input Speed (RPM) Sensor G182 - A - from transmission.

Installing

Installation is in reverse order of removal, note the following:

Electrical connector - C - for Transmission Input Speed (RPM) Sensor G182 is clipped into valve body mount after installing valve body.
Install valve body → Valve body, removing and installing .
Fill ATF → 37 - AUTOMATIC TRANSMISSION - CONTROLS, HOUSING .

Torque specification

Component	Nm
Transmission Input Speed (RPM) Sensor G182 to transmission	9