Wiring harness inside transmission, removing and installing: Installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Installation is reverse of removal, noting the following:

When installing, connect connectors of wiring harness to the corresponding solenoid valves and pressure control valves.
Clip wiring harness into the respective retaining clips. In case of deviations, the wiring harness can be pinched during installation of the valve body.
Installing valve body.
Fill up ATF → ATF, changing or topping off after repairs .