Speedometer Vehicle Speed Sensor (VSS) G22 , removing and installing: Removing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Axle Shaft Shielding Plate

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove heat shield - 1 - for left drive axle (arrows), if installed.

Third bolt is not visible in the illustration.

Fig 2: Removing Speedometer Vehicle Speed Sensor -G22- And Vehicle Speed Sensor -G68-

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect harness connector from Speedometer Vehicle Speed Sensor (VSS) G22 (arrow - A - ).
Push retaining bracket of sensor downward, and turn (arrow).
Remove sensor.