Sensor for transmission RPM G182 , removing and installing: Installing

WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.

Bolt on Sensor for transmission RPM - A - at transmission via bolt - B -. Tightening torque is 9 Nm.
Route wire with connector - C - according to illustration, so that the wire is not pinched when installing the valve body.
Installing valve body.
Fill up ATF → ATF, changing or topping off after repairs .