Oil line inside transmission, removing and installing: Installing
WARNING: This page is about a different car, the 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
Installation is reverse of removal, noting the following:
- Replace O-rings.
- Insert oil line into oil line installer 3381.
- Drive oil line into transmission housing by lightly tapping on the oil line installer 3381 up to stop using a plastic mallet.
NOTE:
- The open side of oil line installer 3381 faces toward the outer wall of the transmission.
- Do not cant oil line. Drive in both line ends uniformly.
- Installing valve body.
- Fill up ATF → ATF, changing or topping off after repairs .
- Check oil level in front final drive → Gear oil in front final drive, checking .