LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (6-Speed Manual Transmission 0A3 All Wheel Drive, Internal Component Servicing) >> 35 - Gears, shafts >> Input shaft >> Input shaft, assembly overview >> Differentiation of input shafts

Differentiation of input shafts

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Differentiation Of Input Shafts
GW00019270Courtesy of VOLKSWAGEN UNITED STATES, INC.

Dimension x = 31 mm on an input shaft without PTFE washer

Dimension x = 29 mm on an input shaft with PTFE washer - A  -

NOTE:
  • After removing 5th gear needle bearing, slide PTFE washer - A  - onto input shaft - arrow  - to stop.
scientia non olet · About LEMON Manuals