Shim " S 5 " for positioning inner race/tapered ball bearing, redetermining
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Positioning Of Inner Race/Tapered Ball Bearing (On Drive Pinion) For Location Of Hollow Shaft In Transmission Is Determined With This Shim
This is necessary when replacing gear set.
- A -.
The actual dimension "A1" - arrow - that you need for this shim " S 5 " is inscribed on gear set ring gear. In the example, dimension "A1" = 98.86 mm
Determine shim needed according to table.
The following shims are available:
| Actual dimension "A1" | Adjustment shim " S 5 " |
|---|---|
| Inscribed value (mm) | Thickness (mm) |
| 99.30 to 99.21 | 2.30 |
| 99.20 to 99.11 | 2.40 |
| 99.10 to 99.01 | 2.50 |
| 99.00 to 98.91 | 2.60 |
| 98.90 to 98.81 | 2.70 |
| 98.80 to 98.70 | 2.80 |
NOTE:
- In the example, shim " S 5 " determined is 2.70 mm.