LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (6-Speed Manual Transmission 0A3 All Wheel Drive, Internal Component Servicing) >> 35 - Gears, shafts >> Drive pinion and hollow shaft >> Drive pinion, disassembling and assembling >> Flange shaft mounting needle bearing, driving in flush in drive pinion

Flange shaft mounting needle bearing, driving in flush in drive pinion

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Driving In Flange Shaft/Pinion Needle Bearing Flush
GW00005965Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install needle bearings with lettering on bearing (the side with thicker metal) facing towards drift 3013.

scientia non olet · About LEMON Manuals