Plate spring and shim, inserting in torsen housing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
- Place plate spring - B - in torsen housing - A -.
- Plate spring installation location: The inner diameter camber faces toward flange shaft in torsen housing.
NOTE:
- Redetermine thickness of shim - C -.
- Place shim - C - on plate spring - B -.
- Place spring - D - on flange shaft in torsen housing.