Selector rod ball sleeves, pressing off and on

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Selector Rod Ball Sleeves, Pressing Off And On

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Support bearing bracket with tube split VW 422.

Place small dia. from the lock pin 2064 in ball sleeve.

Press off previous ball sleeve.
Press new ball sleeve onto dimension - a - approx. 4 mm.

NOTE:

Set ball sleeve in place with inscribed side (thicker wall) facing toward lock pin 2064.