Drive-in depth for ball sleeves in transmission housing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Drive-In Depth For Ball Sleeves In Transmission Housing

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Drive in 5th/6th gear selector rod ball sleeve - 1 - to dimension - a - = 143.5 ± 0.5 mm.
Drive in 5th/6th gear selector rod ball sleeve - 2 - to dimension - a - = 133.5 ± 0.5 mm.
Drive in 1st/2nd gear selector rod ball sleeve - 3 - to dimension - a - = 116.5 ± 0.5 mm.
Drive in ball sleeve for reverse gear selector rod - 4 - to dimension - a - = 116.5 ± 0.5 mm.

NOTE:

Measure with a depth gauge from housing joint surface to respective ball sleeve.