Removing dual-mass flywheel
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Do not use an impact wrench or pneumatic wrench to remove bolts - B - : this would severely damage the dual-mass flywheel. Bolts - B - must always be removed by hand.
- Rotate flywheel - A - so that bolts - B - are aligned centrally behind the holes - arrows -.
- When unscrewing bolts - B - , make sure the bolt heads do not contact the flywheel - arrows - because this would damage the flywheel when the bolts are turned further.
Removing and installing dual-mass flywheel → 13 - ENGINE - CRANKSHAFT, CYLINDER BLOCK