Pedal cluster, assembly overview
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.
1 - Mounting bracket
- Removing and installing → Clutch master cylinder, removing and installing
2 - Pivot pin for clutch and brake pedal
3 - Retaining clip
4 - Hexagon socket head bolt, 25 Nm
5 - Brake pedal
- Maintenance-free bearing, do not grease
6 - Clutch Pedal Switch F36
- Removing and installing → Clutch Pedal Switch F36, removing and installing
- Can only be installed once
- Replace
7 - Hexagon socket head bolt, 5 Nm
- Secures clutch and brake pedal pivot pin
8 - Clutch pedal
- Removing and installing → Clutch master cylinder, removing and installing
9 - Retaining clip
10 - Retaining clip
11 - Hexagon socket head bolt, 20 Nm
12 - Clutch master cylinder
- Removing and installing → Clutch master cylinder, removing and installing
- Gasket - arrow - must not be removed
13 - Over-center spring
- Black side points towards clutch pedal
- Removing and installing → Over-center spring, removing and installing
14 - Clutch Pedal Starter Interlock Switch F194
- Only for USA vehicles
- Engine can only be started when clutch is fully depressed (Clutch Pedal Starter Interlock Switch F194 activated).
- Removing and installing
- Replace
- Do not re-install
15 - Torx bolt, 25Nm
- For securing brake master cylinder/brake servo to mounting bracket