Disconnecting clutch slave cylinder from hose/line assembly

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Hydraulic Line From Slave Cylinder

GW00005234

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing

To remove hose/line assembly, use a screwdriver to pry off clip - A - as far as the stop. Only then can the hose/line assembly be pulled out.

Installing

Press retaining clip - A - in as far as it will go.
Push hose/line assembly into clutch slave cylinder until it engages audibly.
Pull on line/hose assembly to check it is secure.