Clutch Pedal Starter Interlock Switch F194, removing and installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2007 Audi S4, 2007 Audi RS 4, and 2006 Audi S4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

To ensure a secure fit, the Clutch Pedal Starter Interlock Switch F194 must not be installed more than once.

Removing

Remove storage compartment on drivers side →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for Cabriolet
.

Fig 1: Installing and Adjusting Clutch Pedal Starter Interlock Switch F194

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical connector - 3 - on clutch pedal switch for engine start.
Press clutch pedal - 1 - all the way down and hold it in this position.
At the same time, release Clutch Pedal Starter Interlock Switch F194 - 2 - by turning it 45° in the direction indicated - arrow - and pull it out of the guide.

Fig 2: Pulling Out Switch Plunger & Identifying Retainer Tabs On Switch

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Installing

Pull out operating rod - arrow - all the way before installing clutch pedal switch.

Fig 3: Pressing Clutch Pedal All The Way Down And Pushing Operating Rod Against Clutch Pedal

Courtesy of VOLKSWAGEN UNITED STATES, INC.

When installing Clutch Pedal Starter Interlock Switch F194, press clutch pedal - 1 - all the way down - arrowA -. Hold clutch pedal in this position.
Guide Clutch Pedal Starter Interlock Switch F194 - 2 - through opening in retainer, and at the same time push operating rod against clutch pedal and secure switch by turning it 45° in the direction indicated - arrowB -.
Attach electrical connector - 3 - on clutch pedal switch for engine start.
Install storage compartment on drivers side →
- 68 - INTERIOR EQUIPMENT
- 68 - INTERIOR EQUIPMENT for Cabriolet
.